Wire ball, which we usually call cleaning ball, is a common household cleaning tool. It is mainly used to clean grease and stubborn dirt in the kitchen, such as the stovetop and the bottom of the pot.karesponge When using a steel wire ball, we directly take it and wipe it, and our hands will be covered with grease stains after wiping. However, after this treatment, the steel wool ball will no longer be stained and sticky with oil.
First, we need to prepare a discarded beverage bottle. About five centimeters from the mouth of the bottle, use a hobby knife to cut a gap. As the surface of the beverage bottle is very smooth, pay attention to safety when operating. Then, use scissors to cut along the notch, and it is recommended to cut as neatly as possible for subsequent use. Separate the bottle top from the bottle body, and then use a lighter to toast the edges on the bottle top part to avoid scratching your hands during use.
Next, unscrew the cap from the mouth of the bottle and place it on the counter. Use a Phillips screwdriver to poke two small holes in the bottle cap, and then use a knife to enlarge the holes a bit to make it easier to follow. Three wire balls are prepared here. If it is a bigger beverage bottle, we can add some more wire balls. Because I this wire ball is relatively small, so the beverage bottle is an ordinary Coke bottle, the diameter of the bottle is not large, with three wire ball is just right. Then in the middle of the wire ball with a hand buckle out a hole, and then use a piece of string through the hole in the center. It is best to choose a rope similar to the thickness of the shoelace, so that it will not break in use. Tie the remaining two balls in the same way to form a triangle.
Once you have tied the three wire balls together, pass the ends of the string right through the mouth of the bottle. Tighten the string as much as you can and then pass the ends of the string through the two holes you poked in the bottle cap earlier. Next, tighten the string and screw the cap onto the mouth of the bottle. Then tie the string through the cap in a knot and secure the wire ball by tying it tightly. It is recommended that you tie the string in a dead knot so that the wire ball does not come loose. Finally, tie another knot at the end of the string so that you can hang the wire ball after use.
Thus a pot brush made from discarded beverage bottles is complete. Let's verify how well it cleans. Next, we add the right amount of water and detergent to the frying pan. Take this bottle cap part and hold it tightly to scrub the frying pan. As the three steel wire balls are tightly tied together, the steel wire balls are subject to each other's force, and the outer part is wrapped by the beverage bottle, it won't be shifted out of position due to the force of using it, so it doesn't wobble at all when you use it. And the cleaning area is much larger than a single cleaning ball, which is much better than using a wire ball alone. In addition, none of the hands need to get wet with detergent or oil, or even come into contact with water. Wire balls made this way are very practical. After washing the pan, simply rinse the steel wool ball under the faucet and shake it off.
After washing, you can hang the wire ball so that it can easily drain. It won't be greasy and dripping, and it will be clean and tidy for the next use, which is very convenient and practical. Favorite friends hurry to try it.
Related articles:
metal sponge stuffed into a plastic bottle, solve the problem of cleaning, save money and practical
How to Make Homemade Dishwashing metal sponge with Wire Balls and Bottles
Waste steel metal sponge do not throw away, put it in the bathroom kitchen