Marble And Granite Counter Top Processing, The Procedure Needs To Pay Attention To Seven Points

1. Purchasing requirements The width of the table is between 1.95-2.15cm:

2. The thickness from the bought light board is usually 1.90-2.1cm as well as the gloss is over 85:

3, the big trim process records:

(1) Blocks ought to be placed firmly and smoothly in the system.

(2) Understand and see the large cut-off schematic diagram from the stone.

(3) The large-cut size correction and review prior to the lower knife should be careful and accurate.

(4) After cutting the initial three pieces of the block, initial stop and knock from the first stone skin to check on the quality of the block: whether there are any defects such as dark splits, color gall, stains, and color lines; If the thickness is within the allowable tolerance (20mm �� 5mm) and timely correction

(5) Machine inspection, maintenance cleaning and cleaning function should be completed before and after operation.

(6) Complement: It is best to cut (elevation) together with thickened plates, specifically for stone with grain.

4, the width of the process notes:

(1) The actual thickness after thickness setting is 19.5-2.0 cm. Make use of a vernier caliper to check the thickness.

(2) Be careful when handling. Pay attention to safety and steer clear of damage to the sheet.

(3) Machine inspection, maintenance cleaning and cleaning work should be done before and after operation.

5, large surface polishing practice notes:

(1) Please complete the glue before polishing, complete the gap between your Stone Mosaic plate (especially granite), and steer clear of waiting for the finished item to spend a lot of manpower for the beauty glue.

(2) The polishing process is performed with a full set of resin abrasives.

(3) Gloss of 85 or more.

(4) Take care to avoid inadvertent damage to the sheet when lifting the table.

(5) The corners should be ground and the gloss ought to be enough.

6, the bridge shear procedure notes:

(1) To slice the face up.

(2) The saw edge should be sharp. (The blade can be sharpened before the knife is lower)

(3) To control the lower knife and cutting speed.

(4) There must be a machining allowance. (The rest of the amount is definitely 3-4mm, and the seam is defined to within 0.3mm when used for 1/2 round setting).

(5) If the natural stone with grain is to be cut out alongside the thickened part, the texture from the large surface and the thickened edge will be appropriate, and the finished product will be beautiful and Natural Stone Slabs (http://www.chitrust.com/slabs).

(6) Prevent the trend of missing edges, missing edges, not completely cut, cutting, and incorrect size.

(7) Machine inspection, maintenance, cleaning and cleaning work should be completed before and after operation.

7. Gluing and placing process:

(1) To make the colouring carefully, try to adjust the glue to the essential and rock color.

(2) The large plate and the solid plate should be as close as you can. Following the adhesion, repair the clip with iron and fix it to make it glue.

(3) Gluing using a sheet that's in contact with the anastomosis before gluing.

(4) The seam following gluing is not more than 0.3mm.

(5) When gluing, be careful to scrape the excess glue when the glue is still dry, to avoid spending a lot of manpower within the glue during the cosmetic process.