One method of mixing between clipper and shear perform is by using the clipper-over-comb method. Because of this technique, make use of a removable knife clipper with a big edge (#1 1/2 or higher). The bigger blade can give the customer a softer blend since the hair is going to be cut a uniform period with a feathered end. Never use a short edge or trimmer to mix since the knives gives the hair a really frank cut and leave plenty of little lines of demarcation.
Still another way of mixing is blending-shears-over-comb. Raise the hair up with the comb and use the mixing shears to reduce the last 1/4" of the hair. When lifting the hair, it is very important to somewhat overdirect before chopping as this may make a easier blend. Make sure to just reduce the tagliocapelliuomo 1/4 '" to 1/8" of hair. Never thin hair close to the head as this will create a fuzzy search by creating really small locks to stand out through the lengthier hairs. Work with a thinning shear with at least 40 teeth. Shears with larger teeth will generate lines. Avoid applying regular shears to mix because the knives will give the hair an extremely blunt reduce and keep a lot of small lines of demarcation.
You can even develop a mix utilizing a typical straight razor (without a comb attachment). The hair is raked with the razor at a 45 level angle. The position of the edge is extremely important. If the knife is used in a far more flattened place, too much hair will undoubtedly be removed. If the edge is held more upright, it will damage the cuticle. This technique was made common by the Roffler colleges and should not be attempted until you have acquired hands-on training with a barber/stylist who's skilled in the technique. For blade mixing, it is essential that the hair be really wet.
A blade (with guard) or shear-point methods can be utilized to give the haircut consistency by cutting the stops of the hair in clear, varying lengths. Texture is appealing in haircuts that are utilized spiked or disheveled. The blade (with guard) can be used to reel the ends of the hair involving the edge and the thumb to create the various lengths. When dragging the hair between the razor and flash, support the blade at an direction and work with a sweeping motion. The shear-point method is employed to cut the stops of the hair at an direction (or even snipping out alternating pieces) to incorporate texture. Accomplish these techniques just after hands-on instruction from a competent instructor.