The Tutorial to Install VW Golf MK4 Projector Headlights

Today we will find out how to retrofit hid projector headlights for a 1999 to 2005 Volkswagen Golf. We require Phillips screwdriver, flat tip screwdriver, 3/8 drive cog, 1/4drive cog, 3/8 drive cog, 4 to 6 inches in extension, 1/4 drive ratchet about 46 inches in extension, a t30 torx set, t25 torx set, a millimeter socket fix idea snag ring pliers.

Subscribe our site if like our articles.

We begin by opening the hood, now that the hood is open. We gently tug on the corners of the front grille, then release the locking clips on both corners in the shot. Remove the hood latch by unlocking the clip. After the grill has been removed, get rid of the two screws with the red arrows pointed here under, the fender there are also left out to be gotten rid of.

We then eliminate the plastic pieces in the lower part of the bumper, then remove the screw on the upper, left-hand corner by utilizing a torque socket after the screws have been removed. Pull the bumper far from the body of the cars and truck.

We remove the headlight plastic shielding by removing the 2 screws on the top by tugging on the front bumper somewhat. There 2 screws that are below the headlights which likewise require to be removed. When all the screws have been removed, we could typically pull the headlight out a little, so that we can disconnect the harness in the back.

We can now bring the projector headlights and plug in the harness into your original stock. Harness after replacing the projector back into its initial location. Screw on the top two screws and after that continuing screwing the lower two screws.

Put the bumper back into its location and replacing the two screws that are holding it down. we can begin by the front 2 screws and after that the lower screw. After the lower screw has been replaced, we can then change a plastic piece. At this moment, we go back under the bender to put back screws that we removed. We can then put back the hood latch that we took off and lock in the clip back into location. Push the front grille back in slightly so that the clips will lock.

Your setup is now complete please check all lights and signals prior to taking your lorry out on the road.