JustPaste.it

The Way To Spot Common Impression Crusher Blow Bars Problems And Select The Best Ones

As discussed in our article How affect Crushers perform, striker crusher blow bars are responsible for about 75 percent of the crushing operate done within the Impactors crushing room. So, it is important for operators to maximise their usage by using the suitable blow bars.


Shared crusher blow bars Wear Indicators


Over Feeding

Over feeding of this impactor is clear from excessive wear on the outsides of this manganese crusher blow bars. Material has a tendency to charge up along the edges causing more wear. Check out our site for fruitful information about qimingmachinery now.


Underfeeding 

Under feeding will bring about stuff to'trickle' to the middle of the Blow Bar inducing excessive wear at the center of this Blow Bar.


Grinding

Grinding, that's mixture of feeding and packing, will create a sharp burr on the trailing border of this Blow Bar.


The Best Way to see Blow Bar Don problems

The response to fixing improper usage out of the above mentioned instances may appear apparent but demands just a little patience and decent monitoring abilities. By detecting how the impactor is acting, will give a insight into just how the crushing chamber and blow bars are wearing.


Deciding on the Ideal Blow Bar


Martensitic + Ceramic Insert Blow Bars were created primary crushing of feed substances 0- 500mm in proportions. Martensite is a hardened kind of metal however when compared with the other Blow Bars in this list is the lightest, which makes it perfect being a principal crushing pub since it manages large influences nicely and resists scuff or cracks.


FX refers to the amount of chrome carbide, 15% for a FX15 pub. These bars will be used with up feed sizes to 250mm in secondary software or crushing exceptionally abrasive or delicate materials like asphalt and lime.


High Definition FX25 + Ceramic Insert Blow Bars contain a high chrome carbide content of 25% in martensite. These bars will be used with up feed sizes to 150mm in secondary applications or crushing highly abrasive or fine materials like lime and asphalt.


High Definition CR26 Blow Bars comprise the same chrome material to FX25 bars however with no ceramic add, allowing them to crush larger materials whilst still retaining large abrasion resistance. These bars are best used with up feed sizes to 250mm in secondary software or even crushing highly abrasive and/or delicate materials such as lime and asphalt.


Employing the hazemag crusher blow bars on your feed contributes to increased power and also a greater caliber solution, conserving cash on wear parts, and also increasing revenue form production. That helps it be worth the time to shift Blow Bars and keep an eye on crushing overall functionality.